Looking for a Manual or wire diagram to hook up a Haldex Northern Pump No. 1073 on a Meyers plow, I have 2 switches that need hooked up to pump not sure where all the wires get conected.
Thanks
Thanks
Manual Needed
Karl
1 - 8 of 8 Posts
Joined
·
3,402 Posts
Karl, what wire colors are you dealing with and what are the coils labled. Have several manuals here but don't have one that matches your pump. They all usually run the same wiring though.
S1 is Red Angle
S3 is yellow Angle
they are usually on the same side
S2 is black Raise
S4 is Brown Drop
Jerre
S1 is Red Angle
S3 is yellow Angle
they are usually on the same side
S2 is black Raise
S4 is Brown Drop
Jerre
Manual Needed or HELP PROBLEMS
Put 4 wires on pump yellow & red on one side , black & brown on the other side, black wires are nearest to the pump on both side. Plow worked a few time rt. to left & up & down, now all is does is make a clicking noise, what could be the problem? Also getting sparks at lift & hydraulic line is getting warm. I have pump mounted to frame behind plow because no room under hood diesel tk.
Put 4 wires on pump yellow & red on one side , black & brown on the other side, black wires are nearest to the pump on both side. Plow worked a few time rt. to left & up & down, now all is does is make a clicking noise, what could be the problem? Also getting sparks at lift & hydraulic line is getting warm. I have pump mounted to frame behind plow because no room under hood diesel tk.
Joined
·
3,402 Posts
You NEED a ground wire that runs from the Block for the pump to the negative terminal of the battery. The unit is looking for a good ground that's why the hydro lines are getting hot. Hope you didn't melt the filter in the reservoir. and you may have screwed the solenoid and or motor.
What do mean when you say block ? Should I put ground wire to motor where the ground attaches to solenoid. I have had not very little help where I live in southwestern part of the state. The tk. I have had a mount for a Fiher Plow, but I have a Meyers Plow that I fit the light bar & mount for the plow to my tk. Just need to get wires etc. right to use plow.
I can take some pictures & send them to your email. This may help.
Thanks for your help. Karl
I can take some pictures & send them to your email. This may help.
Thanks for your help. Karl
Joined
·
3,402 Posts
You need a ground from the block on the motor to the negative on the battery.
The pump that I have is a Northern Pump Haldex No. 1073 the only place I can see to put a ground from pump to neg. battery post is where the solenoid has the ground connected. I had a ground connected there & the short cable that goes from motor to solenoid got rather warm. I can take a few pictures and send them to you. The tk. has a 3 port module a wire set up for a fisher plow, not sure if that would have thing to do with problem.
Thanks for your help.
Thanks for your help.
1 - 8 of 8 Posts
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
-
?
