I just did a Meyerflush, filter (low and high), and refill on my Quiklift E60. I noticed during the flush cycle that the drop speed was starting to slow down. Left, Right, and Up worked flawlessly. I disconnected plow (wont fit in my shop with plow) and emptied both angle rams completely leaving...

I have a older RT2 v-plow truck has sat a few yrs and I purchased w/out batteries so I wasn’t able to check the plow functions 1st I had to wire a new pigtail on the plow side (11 pin) then check connections at 1st the pump would function with the box style controller but nothing would move...

OK, stupid question #1000: Western Prodigy plow, 6 years old, appears to operate perfectly except: When I push hard with one side, such as trying to slice off a foot or so of a berm, with the blade straight, the pressure will angle the blade, impeding my slicing effort. Is this normal? I have...

2 under tailgate hydraulic salt spreaders for sale at $1,000 each Orange 1: Swenson spreader currently in use. $1,000 Stainless steel 1: Warren spreader will need a $125.00 spinner disc but other than that is operational. $1,000 Will sell both for $1,750.00

My 2006 mm2 w/3 port module stops angling left after about an hours use. I thought it might be the 3 pin connector to the valve bank but then I noticed the pump wasn't running when stick was in left angle. After it sits for a few minutes it will work for a few minutes more. After it sits long...