Does any one have a wiring diagram for a Western MVP V plow 10 pin controller. My controller went from acting funny, push the raise button and the left wing would move but plow won't raise to going completely dead and won't light up at all. Sent controller to a place in Minnesota, Palmdr.com for repair and they checked it out and repaired it and said it was now repaired. But it still will not power up.
Bought the truck and plow used 5 years ago and it had been working fine. Checked out all solenoids and actuators and did find one bad which I replaced (it was the scoop actuator). This did not cure my problem. But then it then went dead.
On the female plug end I have power to 8 of the pins with 2 showing nothing but without a diagram I don't know if this is normal.
I am assuming the plow is 97 model since it was a 1997 F350 city truck and the plow was hard wired on with no 12 pin plug being used and I don't believe it had ever been removed from the truck.
Can't figure it out any help would be greatly appreciated.
Bought the truck and plow used 5 years ago and it had been working fine. Checked out all solenoids and actuators and did find one bad which I replaced (it was the scoop actuator). This did not cure my problem. But then it then went dead.
On the female plug end I have power to 8 of the pins with 2 showing nothing but without a diagram I don't know if this is normal.
I am assuming the plow is 97 model since it was a 1997 F350 city truck and the plow was hard wired on with no 12 pin plug being used and I don't believe it had ever been removed from the truck.
Can't figure it out any help would be greatly appreciated.
