Snowplow Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Installing on a 2005 Dodge ram 1500. Plow came off of 2002 dodge ram 2500
1608653485164763323197121269972.jpg
Plow is mounted and is a two plug. I currently have full plow controls and all lights except for low beam on plow. Both relays are clicking when lights are turned on. When plugged in lights do switch to plow. Every single connection has been cleaned/replaced and anti oxidation protected.
16086540025875397087343554932367.jpg
16086541566513621426415436517387.jpg
Drivers side tag.
31059
just two relays.
31061
please let me know any advice. There is no module with these used parts the customer brought. Only number on harness found is w 61437, f 8275, rev. 7 Here is info on western I found.
31062
can I make this work simply?
 

·
Registered
Joined
·
353 Posts
I do not think the headlamps worked the same, if it was me i would just run a toggle switch for the headlamps as long you can turn off the daytime running lamps.
Just wire them into the harness, and wire in your parking and T/S lights. Easy to do.
 

·
Registered
Joined
·
2 Posts
Discussion Starter · #3 ·
The relays switch the high over but not the low. This is my biggest puzzle. A single toggle with low beam wire only and leaving the rest as it is should work yes?
 

·
Registered
Joined
·
353 Posts
On.off on 30 amp rated toggle switch, power to the center, other wires run out and connect to the western harness out to the plow, you will have high and low beam, and install a fuse in the supply wire.
 
1 - 4 of 4 Posts
Top