Snowplow Forums banner

1 - 11 of 11 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hello Group.
I am as green as they come when it comes to snow plows this is my first one.

I just acquired a used truck with a fischer plow to plow our shop lot. but it wont move!!

I have cleaned all the grounds and contacts and it makes a clicking noises at the 3 solenoids so i know the joy stick works and the power is connected correctly. I have used jumper cables directly to the terminals on the plow pump and it turned.

What do i need to look at next? could all 3 solenoids be bad? I do not know when this plow was last serviced and from the condition of the truck i am going to say it has never been serviced.

What do i need to do to service it ??

any points in the right direction would be greatly appreciated. i do think it is somthing simple

thanks in advance
 

·
Registered
Joined
·
5 Posts
Discussion Starter #3
no the plow is on a set off rollers off the truck in the driveway . i just pulled up to the truck and hooked up the connections to try and move it before i try mounting back on to the truck
 

·
Registered
Joined
·
123 Posts
Then you a test light to probe for positive and negative at the respective positions. That will tell you where you are missing the inputs.
 
1 - 11 of 11 Posts
Top