So today I cleaned off the grease and used the electric stuff. I also replaced a factory ground(block to firewall) that was broken. Now I have power to 2 of my fuses, the other that's just a loop there's no power and still no power at my stick. Am I missing something here?
I’ve tried everything I can think of:
confirming the Unit is turned off
turned off headlights manually
waiting it out (still illuminated two days after last time truck ran)
dimmer switch turned down
holding down on power off button
What‘ve I missed?
I can only find notes online about...
When angling or raising plow ratchets intermittently then will angle or raise. Moves fine when it does go . Plow may not drop all the way. Moves normally when it does go,seems like the pump is fine. Could this be bad controller. Seems like there's no sensitivity to the controller. Fisher MM2...
Does the Isolation moudeal have anything to do with power to the control if it were bad ? Plow worked when put away last spring. Have cleaned all connections and checked fuses. Not getting any power to any pins on control plug. Can you help, is snowing and i am stuck!