Snowplow Forums banner
1 - 4 of 4 Posts

· Registered
1 Posts
Discussion Starter · #1 ·
I have an older boss straight blade and the electric motor burnt out. Part number 2201094. They dont make that part anymore so boss told me to use part number hyd09328. As you can see in the pictures the bolt holes do not line up if the dowelpin is in place. If i do a quarter turn the bolts line up but the dowel pin does not. Boss told me to drill new holes but the magnets are in the way. The blue dots are where the holes need to be. What is the solution?


1 - 4 of 4 Posts