Snowplow Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Can someone please tell me how to test the hydraulic pump valve solenoids and how to set the pressure relief valve. The snowplow is a Artic the power unit is the M637 older version
I had the snowplow installed it wouldn’t lift off ground angle left or right the motor sounded like it was spinning nothing was happening any help on how to check those things put be extremely appreciated as we got Ton of snow where I’m at here in Thunder Bay
 

·
Registered
Joined
·
193 Posts
You could try jumper cables right to the motor and see what it sounds like.
Might have to remove the motor to access the pump and inspect for damage to the pump gears
 
1 - 6 of 6 Posts
Top