Snowplow Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
8,323 Posts
If everything else works fine,it's probably just a quill adjustment.

On the top of the valve block,there is a small flat head screw.Turn it in to slow the drop speed.It is a very sensitive adjustment,1/8-1/4 turn is probably all you will need.
 

·
Registered
Joined
·
24 Posts
Older Western the drop valve is on the back of the pump housing, loosen the large nut 1/4 turn, hold nut in that possition, screw allen screw in 1/8 to 1/4 turn, tighten nut. Make this adjustment with the blade down, less chance of blowing out oring under nut
Steve
 
1 - 5 of 5 Posts
Top