Snowplow Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter · #1 ·
hi i vae the two toggle switches to replace and of course i didnot write down what went to where. please help! they are numbers on the pics, both are exactle the same so i only took one pic but i need to replace both



chris
 

Attachments

·
Registered
Joined
·
609 Posts
depending on weather it is a lift or angle...

lift switch

1; red wire coil
2; solenoid
3; hot +
4 ; black wire coil

angle switch
1; green wire coil
2; solenoid
3; hot +
4; solenoid
 

·
Registered
Joined
·
1,741 Posts
That's correct. I think Nate may have made other mistakes though? Hard to tell in the diagram but here's what I see: According to the diagram I am looking at, it should be a white jumper wire that actually goes to #1 which then jumps again to # 1 on the Lift switch. That also has a white connected to it going to the solenoid. Both #3's are jumpered together & are connected to an ignition positive. So the #2 on the angle switch would be the green to C coil. And the #2 on the lift switch would be the red to B coil. So I would say:

lift switch

1; solenoid
2; red wire coil
3; hot +
4 ; black wire coil

angle switch
1; Solenoid
2; green wire coil
3; hot +
4; solenoid
 
1 - 4 of 4 Posts
Top