Snowplow Forums banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter #1
Hello, hoping to find some help, I have a Meyer E60 pump, I recently rebuilt, my first time ever having one apart. After completing and testing I only have the angleing left and right working, ram will not raise, it starts very slightly but that’s it. Fluid level is good, the “A “ valve seems to also be good, I did buy a new valve but the diameter of the stem is too big so I wasn’t able to install. Either way Im thinking maybe I put something in wrong during the rebuild. Any ideas ? Thank you
 

·
Registered
Joined
·
2 Posts
Discussion Starter #3
I bought a valve but wasn’t able to replace it because the shaft size that the coil fits on is too large. However my existing valve appears to be working, at least based on the limited test I was given. I will try to test the pressure and see what I come up with. I’ll look for a testing procedure on that. Thanks
 
1 - 3 of 3 Posts
Top