Snowplow Forums banner

Meyer E57 only angles right.

2K views 2 replies 3 participants last post by  pwong319 
#1 ·
Hi everyone!
I have a recently rebuilt e57 that I set up on my truck and it worked great. Went left, right, up and down. Had some mechanical work to get done on the truck so disconnected the blade. A few weeks later I go to hook the plow back up and blade goes up and down but if I angle left it does opposite and goes right and is stuck right. One hose is left pressurized and have to tap the fitting off with a hammer. I have replaced the couplers and c coil is good. C coil comes off the valve fairly easy and is not swollen. Any help would be greatly appreciated!
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top