Snowplow Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter #1
Hi All,
can anyone tell me how to remove the motor on a Snowdogg MD68? The manual is useless, and so is the factory help... Dire straights here....
Thank you!
Mark
 

·
Registered
Joined
·
94 Posts
Should have 2 bolts or screws going through the motor housing attaching to the pump base.
Might be 2 hex heads or Phillips heads. Usually giving them a light tap with a hammer on the bit helps to break them loose. Good idea to use electrical grease on the threads and the mating surface of the pump motor.
 

·
Registered
Joined
·
228 Posts
If I remember correctly, a cover with two screws at end of motor, remove the cover, then will see two screw or bolt heads, these are long bolts that hold the motor to the housing. Remove these two, motor comes off.
 
1 - 4 of 4 Posts
Top