Snowplow Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter · #1 ·
I have a staright blade hiniker 7.5 and need to replace the 7 pin male and female connectors on the controller(I don't want to spend $200 for a new controller). I have been looking everywhere for a 7 pin male female connectors preferably round like the oroginal but any would do at this point. Any suggestions would be appreciated. Sorry if this is in the wrong place but I didn't know where else to put it since there is no Hiniker forum
 

·
Registered
Joined
·
8,323 Posts
Any good electrical place should have connectors available.You could use just about anything.It might be easier to find two small 4 prong connectors instead of one larger one.

You could even do it with regular spade connectors,but you would have to plug them in one by one.

Radio shack usually has a good selection of connectors too.
 

·
Registered
Joined
·
66 Posts
If you give me a picture of the connector you need, I might be able to find one.
Or
Here is some parts number for another type of connector. (Western, fisher and boss use them)

However they do not make a 7 pn so here is a 9 pin.

Digiikey

9 Pin Plug = Part# WM1226-ND = $0.69
9 Pin Rec = Part# WM1236-ND = $0.69
Male, Crimp Type Terminals = Part# WM1000-ND = .073
Female, Crimp Type Terminals= Part # WM1001-ND = .077

Let me know if you need anymore help.
 
1 - 3 of 3 Posts
Top