Snowplow Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
62 Posts
Discussion Starter · #1 ·
I changed and flushed the fluid on my MC plow now I can't seem to get it bleed. There is'nt a breather on the commerical pump like on my 9.5V. You can hear the air in it when you angle right-left.When you Pull the plug on top I get a lot of air and fluid spilling out.Any ideas.
Thanks Todd
 

·
Registered
Joined
·
121 Posts
If there is no breather than you must have the SEHP system where the lift cylinder is part of the hyd. unit? If so make sure you have plenty of fluid in it before you start the bleeding process or you will create a lot of foaming from the system sucking air. It takes almost 3 quarts of oil to fill this unit. On our website type 8425 in the search box for info on this unit and scroll till you see the filling instructions. You can also leave the fill plug loose a couple of turns to allow the air to escaoe easier. Just keep an eye on it.
 
1 - 2 of 2 Posts
Top