Snowplow Forums banner
1 - 5 of 5 Posts

·
Registered
Joined
·
155 Posts
Discussion Starter · #1 ·
I have an 85 K-10 w/ a Vortec Headed 350. The stock gauges are crap. So I have no more a/c. So I made an "engine turned" panel to hold two gauges. This also complements my "engine turned"
switch panel as well. I wll post pics when I have finish the install.
T.J.

 

·
Registered
Joined
·
668 Posts
I'm liking it already, that looks sharp (as in nice, but it might be sharp too?). A dash like that would be very flashy (pun intended):D
 

·
Registered
Joined
·
1,440 Posts
That's a very nice machining job!

Have you considered a Transmission Temperature gauge as well?
 

·
Registered
Joined
·
445 Posts
I agree with SnowyBowtie if you can add a tranny temp guage
 

·
Registered
Joined
·
866 Posts
That is also one thing I would add- I'm in the process of looking to add one myself. Keeping that temp down is a must when working your transmission as hard as we do on a regular basis!

I like the look and would like to see how your switch panel turned out - any chance of getting some pics after the install?

Bill
 
1 - 5 of 5 Posts
Top