Snowplow Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
6,272 Posts
Discussion Starter · #1 ·
I have an e-60 for a diamond plow it works fine but then sometimes it will not raise or angle .after a min it will start to work again .Any ideas what it could be? maybe the switch?
 

·
Registered
Joined
·
1,741 Posts
Check that all of the wires are connected well, and not caked with ice, snow etc. Happened to me a few times today also, finally got tired of it & got my lazy tired butt out of the truck & snugged up the wires. I usually seal up those connections with electrical tape so they can't get iced up or knocked loose during the battle with Mother Nature. Last minute pump change so I didn't seal them up this time as it was already snowing.
 
1 - 2 of 2 Posts
Top