Snowplow Forums banner

1 - 1 of 1 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter #1
Recently i changed my sno pro 2000 from an 1984 f-250 to a 1988 f-250 all went well except control wiring when i try to lower the unit to float it does not work, however if i leave it in float and activate the power angle switch it goes right down. Im wondering do i just have a wire hooked up wrong, or is the float switch bad. Any help please! Thanks everybody this is a great site and i have been on the phone w curtis waiting 30 min then i hung up. I down loaded the 3000 series format but i'm not showing the complete schematic behind the switch
 
1 - 1 of 1 Posts
Top