Snowplow Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
So far I have replaced Truck side and plow side power harness/battery cables, 11 pin truck side, plow module, isolation module, controller, 3 different solenoids and put 2 brand new batteries in the truck.
Now when i try to move the plow the solenoid wont engage i can hear the actuators clicking(not solenoid the actual hydraulic valves opening and closing) but no movement. If i jump the solenoid the plow will function. I am starting to think i received a faulty plow module from the factory. plow will go down when i hit down on controller without jumping solenoid. Is there any way to actually test the plow module or has anyone had any experience with this issue. Two diffrent plow shops have looked at it and i paid well over $1000 for repairs the first time still no luck.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top