Snowplow Forums banner

1 - 6 of 6 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter #1
Hello,

I have blizzard 810 plow. Plow side harness plug got squeezed in plow and i replaced the whole harness. But still not working. Plow is sitting on ground cant wven take it to mechanic. Any suggestions how i can lift it and keep in lifted position, so i can drive to mechanic
 

·
Registered
Joined
·
329 Posts
Connect to the plow, raise it with a floor jack, then secure it with a few ratchet straps, heavy duty ones.
 

·
Registered
Joined
·
164 Posts
If this is an original 810, then what you can do is crack the lift cylinder hoses, jack with floor jack as said....on the side of the lift frame there is a transport pin hole just for this purpose. Take one of the pins out of the push frame and install it in the transport hole, lower the jack and your good to go.
 

·
Registered
Joined
·
164 Posts
You have to get the fluid out of the lift cylinder in order for you to lift the plow.
I was assuming the plow was hooked to the truck already....but misread that part.
You should be able to drive into the plow, and use the floor jack to lift it up to install the pin in the transport hole.
 
1 - 6 of 6 Posts
Top