Snowplow Forums banner
1 - 4 of 4 Posts

·
Registered
Joined
·
133 Posts
Discussion Starter · #1 ·
the rubber sleeve that the keeps the water from coming in on the lift cylinder, what is the easiest way to install a new one?, I keep bending these things, I use a wood block and a malet and it aint working....
 

·
Registered
Joined
·
133 Posts
Discussion Starter · #2 ·
I need help!!!!

I need to find an easier way to put a new rubber guide sleeve on the top of a E-47 pump, I tried putting a metal plate on top of it and hitting it with a malet, but i keep bending them:huh
 

·
Registered
Joined
·
3,632 Posts
The plastic sleeve on the inside of the top cap can be put in with a socket of the right size. Flip it over and use an extension in the hole from the inside to hit with a hammer This will drive it flush and then a smaller one to finish seating it.

You can do the same thing for the top seals.
Jerre
 
1 - 4 of 4 Posts
Top