Snowplow Forums banner
1 - 2 of 2 Posts

43 Posts
Discussion Starter · #1 ·
I am putting on a 200 amp alternator on my F250, they told me I should run a 4 gauge wire back to the battery. Can I just disconnect the exsisting wire from the alternator put the new wire on and connect it to the positive side of the battery.

I noticed there are a few other wires in the wiring harness and I am having trouble figuring out where they go.

Thanks for the help in advanced:burnout
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.