Snowplow Forums banner

1 - 7 of 7 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter #1
Hi all. Snows on the way and of course my plow will not raise. Selonoid switch works and I’ve tested that I’m getting voltage to the main positive lug on the motor and to each selanoid For down pressure and right and left angle.

I’m not getting a peep from the motor itself even though it’s getting voltage to it. I’ve cleaned positive and negative cables but still nothing.

Any ideas or direction? If the heavy red cable that runs to the motor to has voltage when I use the remote and each of the 3 selonoids do as well, what else could I be missing?

Any idea on how to separate the motor side from the pump side?

thanks
 

·
Registered
Joined
·
66 Posts
Take a set of jumper cables straight from your battery, to the plow motor and see if the motor runs. If it does not then your motor is toast.
 

·
Registered
Joined
·
5 Posts
Discussion Starter #6
Thanks to the both of you. New motor off eBay is only $90 so assuming that’s the problem it should be back up and running relatively soon.
 
1 - 7 of 7 Posts
Top