Snowplow Forums banner

power post on motor

4K views 5 replies 4 participants last post by  DeVries 
#1 ·
We've got a 9 foot artic blade that has a loose post where the power wire attaches. Sometimes the plow won't go up until we wiggle the wire that is connected to the post.

The wire is tight on the post but the post is loose in the motor. Can this be tightened or will it break a solder inside the pump motor?
 
#4 ·
#5 ·
We bring ours to the local starter/altenator repair shop and they rebuild the the motor for like $55.
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top